You’ll thank yourself when it’s still holding up better than plastic. If you can afford it, find a drill with a metal chuck. Unless I get another plastic chuck DeWalt (and in the future one with a metal chuck) for batteries and the DCA1820, the thing is a total loss. For smaller bits, tighten the chuck by hand until the bit sits. For larger bits, loosen the chuck by hand until the bit fits inside the chuck. Every time I’ve used NiCd packs, they’ve been nothing but terrible. Want to know how to change the drill bit in your black and decker drill In this video I go through the safe way to change your drill bit as well as the speedy. STEP 3: Insert the new bit and twist the chuck closed. As far as batteries go, it isn’t worth buying any because I can only choose 3rd party NiMh or 1st/3rd party NiCd. It’ll never be perfect again because of the obvious internal issues and beating I did, but I intend to use it until the batteries are dead. It also helped how smoothly the chuck moves as well, so it compensates for any potential damage. It has always worked fine since but that may be in part due to the fact I put 3-in-1 oil in the chuck to help it post beating and sanded the rust inside as I can to prevent that from causing another problem. It didn’t happen on mine since the pre-20V DeWalts often use a Jacob’s chuck (not true on the newer 20V ones!), so YMWV based on who made the chuck. It may damage some cheap chucks beyond repair, so keep that risk in mind. That was sufficient to beat on the cuck and loosen it with brute force. What I did to fix it is I locked the motor switch and got scrap wood and bent the bit to a 90 degree angle. Most of the time you can get a new bit individually or in a bit set if the cost is just about the same. The bit WILL be sacrificed, so if you need it and can’t quickly replace it find a non-destructive solution. There’s a way to get the bit out that worked on an inherited Dewalt DC970, but it is sacrificial to the drill bit stuck in the chuck.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |